Communication between fiber optic channel and relay protection

Feb 20, 2023|

Communication between fiber optic channel and relay protection

 

 

There are mainly two ways of communication between fiber optic channel and relay protection: dedicated fiber optic communication and multiplexing fiber optic communication. Each communication method has its own characteristics and applicable situations, and it should be used according to the actual situation during using choice.

 

fiber optic protection

 

The first is a dedicated optical fiber communication method. The dedicated communication mode only transmits relay protection information, but not other information, mainly because the dedicated communication mode is a dedicated optical fiber channel specially established for relay protection. The communication distance of the dedicated communication mode is generally within 100km, which can meet the basic requirements of power companies. This type of method has the characteristics of high transmission efficiency, simple method, no intermediate links and equipment, etc., and can be practically and effectively applied to short-distance relay protection information transmission.

 

The second multiplexing optical fiber communication method. The multiplexing communication mode is mainly composed of the cooperation of various optical fibers in the longitudinal protection. The relay protection device will send out a permission signal and a direct jump signal in the permission mode, and then the signal will be transmitted to the relevant multiplexing equipment through the audio interface, and then transmitted to the fiber channel. Simple wiring is a major advantage of this transmission method, which plays an important role in promoting the maintenance and operation of the circuit system. The multiplexing optical fiber communication mode is widely used in long-distance line protection.

Due to the many advantages of fiber channel, it is widely used in relay protection equipment. With the development of the times and the advancement of science and technology, my country's relay protection will be oriented towards informatization, networking and intelligent development in the future. Component optical modules bring higher requirements. On the one hand, there is huge market potential. In 2021, the market segment of optical modules related to relay equipment will ship nearly 300,000 units. It is estimated that the annual market demand will increase by 15%. On the other hand, thermal control and thermal design of optical modules are more severe challenges. Requirements for the stability and reliability of relay protection equipment limit some commonly used heat dissipation designs, such as prohibiting the use of fans in the equipment; higher protection level requirements limit the heat dissipation of chassis openings. Usually, only natural convection and conduction can be used to control the internal ambient temperature of the equipment to meet the operating requirements. Therefore, under the condition that the board-level heat consumption continues to increase and some traditional heat dissipation methods are limited by standards, it is very difficult to carry out effective heat dissipation design for modules. Effective product thermal design methods are required, and new The introduction of new processes for materials.

 

The reasonable application of optical fiber communication technology can smoothly improve the functionality and safety of relay protection, thereby successfully meeting the basic needs of power companies, completing the protection of related lines, and promoting the safety and stability of power systems.

Send Inquiry